① When the machine is shut down, the silk woven on the machine must first be left off the machine to prevent it from being placed on the machine for a long time, damp and moldy.
② Rinse the reed and the fallen slurry accumulated on the healds with water, and try to clean them as much as possible to lay a good foundation for restarting the machine in the future.
③ Relax the warp tension, remove the heavy hammer, and shake the heald frame into a flat condition to prevent the warp from being stretched by the opening for a long time.
④ Put down the water baffle and waterproof cover on the loom and cover it.
⑤ Raise the pinch roller lifting rod to prevent the pinch roller from deforming.
⑥ Cut off the power of the machine, turn off the water source, pay attention to safety and save energy.
⑦ Take out the circuit control board in the electrical box and store it in a ventilated and dry place to prevent it from being affected by moisture.
⑧ If all the looms in a workshop need to be stopped, the main power supply and the main water source should be cut off, and the situation should be checked regularly by ventilation and moisture removal, and the workshop should be ventilated and dry.